Home >> >> The Difference Between Conventional and Synchronous Pumps

The Difference Between Conventional and Synchronous Pumps

Safety and efficiency are always the primary concern on a job site, but equipment budget and availability are a huge factor in what tools make it to the table. While Synchronous Pumps feature increased safety and efficiency over conventional, non-unified pumps, they may not always be available. It is important to understand the hydraulics being used to operate your Jacks or skid system to ensure a safe and successful move.

Hydra_Pack_pump.jpgWith conventional power units there is a single oil supply circuit. It may be split into more than one outlet port but they are connected and so act as one. The pressure will remain constant in all lines but the flow rates may be different.

Considerations when using a conventional pump:

If the load is heavier on one side, the cylinder with the least load will advance faster than the cylinder on the heavier side. What this means during a move is that when jacking, it is necessary to jack only one end at a time (end-to-end jacking) to ensure that the load can never tip. When skidding, it is necessary to ensure that both cylinders advance at nearly the same rate. Hydra-Slide’s conventional power units are equipped with flow control valves to help control the flow rates to each push cylinder.

Considerations when using a Synchronous pump:

Hydra-Pac Synchronous power units contain multiple but independent oil circuits. The circuits are not connected to each other and will give equal flow to each line regardless of the weight of the load or the pressure in that circuit. We accomplish this by using specially designed piston pumps, valves and control devices. This allows the user to raise almost any load straight up, safely and equally at all points without fear that one side will raise faster than the other. We have also employed counterbalance valves on the return side to ensure that the load can be lowered evenly and synchronized and always slow and under control, even in the case of a crushed block pile or hose rupture.

When jacking a load with an offset center of gravity, pressure readings on each circuit may be different but each will provide the same flow rate, allowing simultaneous jacking of multiple points without end-to-end jacking, greatly increasing the speed and safety of the operation.

Janine Smith

Janine Smith

Janine Smith joined Hydra-Slide Ltd. in 2011 as Director of Sales & Marketing to better serve its growing client base. She is the first point of contact for many of Hydra-Slide's new and returning customers. Janine was promoted to Vice President in 2015 and enjoys her growing responsibilities including Inventory and Brand Management, Logistics and Client Relations.

Subscribe to Blog Updates

Find us on Facebook